Skip to content

🚚 We're Working Non-Stop & Trading As Usual

Simple Steps to a Whiter Smile

STEP

1

Try a dry run first

Before you get started, we strongly recommend that you undergo a dry run of the process a few times to get a feel for it. Begin by positioning your first retainer so that it covers your upper Grid of teeth. Use your tongue to hold it in place, and suck all of the air out so that the retainer is firmly contoured around your teeth. Repeat this process with the second retainer covering your bottom teeth.

STEP

2

Dip the first retainer in boiling water

Boil a saucepan full of water, then take it off the heat. Holding your retainer by the protruding tab, carefully dip it into the boiling water (make sure the edges don’t curl as you do so). Keep the retainer completely submerged in the water for a count of 5 seconds.

STEP

3

Mould the retainer to your upper teeth

After 5 seconds is up, take your retainer (while still grasping the tab) and carefully place it over your upper teeth. As you did in step one, use your tongue to hold the retainer in place while you suck out the air. Once snugly fitted to your teeth, use a pair of scissors to snip off the tab at the front of the retainer.

STEP

4

Repeat above steps for the second retainer and your lower teeth

Simply repeat steps 2 and 3 for your second retainer, ensuring it fits snugly to your lower teeth.

STEP

5

Apply the whitening gel

After brushing your teeth using a fluoride toothpaste, apply a dab of the GOGO Smile Teeth Whitening Gel into each tooth ridge of the front areas of the retainers (the gel only needs to be applied to your visible teeth). Be careful not to overfill, as the gel may irritate your gums. Carefully place each retainer over your front and bottom Grid s of teeth, making sure the gel does not come into contact with your gums.

STEP

6

Apply the LED accelerator

Place the LED Teeth Whitening Accelerator Light in your mouth, making sure it is pressed up against the retainers. Wrap your lips tightly around it to hold it firmly in place. Turn the accelerator’s light on and leave for 15 – 30 minutes. Once the time is up, simply remove the accelerator from your mouth and take out your retainers. Make sure you give them a thorough rinse after each use.

Repeat the process daily until you reach the desired result.